Contact Us   Feedback
PRODUCT CATEGORY
CABLE TRAYS/ LADDERS
   Indoor Cable Trays / Ladders
   Indoor Cable Tray / Ladder Accessories
   Outdoor Cable Trays / Ladders
   Outdoor Cable Tray / Ladder Accessories
ANTENNA MOUNTS/ FIXTURES
   GSM Pole Mounts / Microwave Mounts
BTS MECHANICAL AND ELECTRICAL
   Wall Entry Plates for Feeder Cables
   PVC Feeder Clamps
   Stainless Steel Hangers
   BTS Ancillary Kits, Installation Material     & HDW Accessories
   Krone Products
   Jointing Sleeve, Insulating Cover
   Grounding Kits
   Grounding Bars & Ground Bar         Assemblies
   Weather Proofing Kit
   19” Communication / Microwave /
    Server Rack
STEEL FABRICATED PRODUCTS
   AC & DC Distribution Boards
   L.T. Incomer / Metering Panels /     
    SFU Boxes
   Power Distribution / Interface Unit
RF PRODUCTS
   RF Connector & Adaptors
   RF Components
   RF Co-axial Jumper Assemblies
   RF Cables
CABLES
   8/ 10/ 12/ 16 Pair PCM Cables
   Power / Grounding Cables
   Alarm Cables
   Cats / Cat6 Cables
FIBER DISTRIBUTION PRODUCTS
& ACCESSORIES
   Fiber Management System (FMS)
   Fiber Optic Connectors & Adaptors
   Pigtail & Patch Cords
   Splice Protection Sleeves
   Fiber Optic Attenuators
Products > BTS Mechanical and Electrical > Grounding Kits

We recommend three Grounding Kits per feeder run. One kit is required at the top, one at the bottom of the run, (plus one at 50 meters interval wherever applicable) and one at entrance to the equipment shelter.

Grounding kits that have been specially tailored to each cable size can be installed very easily and rapidly; once the jacket is stripped at the required dimension, one kit can be installed in less than three minutes. Kits are provided all hardware necessary to connect the ground wire to the tower ground bar.

A well designed system uses grounding kits to provide a bond between the cable and the tower/ earth ground system. One grounding kit is recommended at tower top, tower bottom, at 200 ft (60 m) intervals (where applicable), and at the entrance to the equipment shelter. The non-braided solid copper construction of all grounding kits eliminates corrosion caused by moisture retention and "wicking". A heat shrink tube protects the cable terminal connection.

GK for 1 5/8" Cable
GK for 7/8" Cable
GK for ½" Cable

The Compact Grounding Kits have been tested and present a low contact resistance. They have been tested to withstand 6.000/Volts/150.000 Amps. The cocoon style UV resistance rubber shell once correctly installed will allow an IP 68 waterproofing index (1m/24h) with no need of any additional protection.

For Standard Grounding Kits , the stainless steel shell ensures high resistance to corrosion and the rubber gasket guarantee an IP67 waterproofing level. The solid copper contact has been tested according to MIL STD 1757 providing high protection against lightning.

Grounding Kits divert transient currents from lighting off the transmission line to an earth grounding system to prevent damage to cable and radio equipment. A typical wireless RF system installation uses three grounding kits: near the top of the main feeder cable, at the bottom of the main feeder prior to the horizontal run, and just prior to the cable entering the building or shelter.

 
Request A Quote
Print This Page
Bookmark This Page
   Best view in 1024x768
                                               Home  |  Company Profile  |  Products  |   Quality Policy  |   Enquiry   |   Career
   Designed By : Cent Websoft Technologies
Copyright © 2015 Dipti Telecom >> All Rights Reserved.
DIPTI TELECOM